变更地籍测量成果资料的变更有：宗地面积变更、地籍图及宗地图变更、界址点坐标册变更、面积汇总表及统计表变更等。

　　一、宗地面积变更

　　变更地籍测量宗地面积变更应在充分利用原成果资料的基础上，采取高精度代替低精度的原则，即用精度较高的面积值取代精度低的面积值。属原面积计算有误的，在确认重新量算的面积值正确后，须以新面积值取代原面积值。

　　宗地面积变更应分三种情况：变更前后均为解析法量算的宗地面积，如原界址点坐标满足精度要求，利用原界址点坐标计算宗地面积；变更前采用图解法量算面积，变更后采用解析法量算面积的，应利用解析法量算的宗地面积取代原宗地面积；变更前后均采用图解法量算的宗地面积，对宗地形状未变或宗地合并的，如两次面积量算差值满足规定限差要求，仍以原面积数据为准，如两次面积差值超限，则应查明原因，取正确值。

　　对宗地分割的宗地面积变更，如变更后宗地面积之和与原宗地面积的差值满足规定限差要求，将差值按分割宗地面积比例配赋到变更后的宗地面积，如差值超限，则应查明原因，并取正确值。

　　二、地籍图及宗地图变更

　　（一）地籍图变更

　　采用数字法测绘地籍图的变更，数字地籍图应随宗地变更而随时更改，但要保留历史上每一时期的数字地籍图现状。

　　采用模拟法测绘地籍图的变更，地籍铅笔原图作为永久性保存资料，不得改动；地籍二底图应随宗地变更而随时更改，发生变更时，在二底图复制件（蓝晒图或复印图）上用红色笔标明变更情况，存档备查。也可将一定时间内的变更内容标注在同一张二底图复制件上，一宗地变更两次或全图变更数量超过1/3时，应重新绘制二底图。根据变更勘丈成果或变更宗地草图修改二底图的有关内容，去掉废弃的点位、线条和注记，画上变更后的地籍要素。为保证地籍图的现势性，当一幅图内或一个街坊宗地变更面积超过1/2时，应对该图幅或街坊进行基本地籍图的更新测量，重新测绘地籍铅笔原图。

　　（二）宗地图变更

　　宗地图是土地证书的附图，变更地籍测量时，无论变更宗地界址是否发生变化，都应依据变更后的地籍图或宗地草图，按《城镇地籍调查规程》有关规定重新绘制宗地图。原宗地图不得划改，应加盖“变更”字样印章保存。

　　三、其他资料变更

　　（一）界址点坐标册变更

　　对界址点坐标册中已废弃的界址点坐标及界址点号用红色笔划掉，在相应位置加盖“变更”字样印章；采用解析法重新测量的界址点，将原界址点坐标用红色笔划掉，并在其上方标注新测数据；新增加的界址点坐标及界址点号加在坐标册中；当界址点坐标册变化较大时，应重新编制界址点坐标册。

　　（二）面积汇总表及统计表变更

　　在以街道为单位的宗地面积汇总表内，划掉发生变更的宗地面积数，并加盖“变更”字样印章，将新增加的宗地面积加在表内。

　　根据本地实际情况，视一定时间段，依据变更后的街道“宗地面积汇总表”，变更城镇土地分类面积统计表。

　　（三）相邻宗地变更

　　由于变化宗地地籍要素的变更引起相邻宗地地籍要素变化的，相邻宗地需进行相应变更。如果宗地的变更只引起相邻宗地四至变化，而相邻宗地其他地籍要素未变的，相邻宗地四至状况可暂不做变更。

Change cadastral information on changes to the results are: land area is changed, cadastral plans and maps were changed, Boundary point coordinates volumes change, size change summary table and tables and so on.

1, Parcel Area Change

Cadastral survey were to change the size to change the outcome should make full use of the original basis of the information, instead of taking high-precision low accuracy of the principle that an area with high precision the value of the area to replace the low precision values. Is the original area of an arithmetical error, in the area confirmed the re-count the value of the correct amount, shall be replaced with a new area value in the value of the original area.

Parcel Area changes shall be sub-three situations: to change both before and after the analytical method were counted the amount of land area, such as the original boundary point coordinates to meet the accuracy requirements, the use of the original boundary point coordinates were calculated in area; change the amount of graphic method used before the calculation area, change the amount of analytical method used after the area calculation, the amount of analytical method should be used to count the cases of land area were to replace the original area; change the graphical method used before and after the count of the cases the amount of land area in the shape of the case has not changed or were merge, such as the difference between the two areas considered to meet the regulations limit the amount of bad requirements, is still subject to the original size of data, such as the difference between the two areas overrun, it should identify the reasons for taking the correct value.

Divided by the number of cases to an area of change, such as the area after the change were to the sum of the original cases in the area to meet the margin requirements the provisions of allowable error margin would be divided according to the proportion of cases assigned to an area assigned to the area after the change were to , such as the difference overrun, they should identify the causes and take the correct value.

2, cadastral plans and maps were changed

(A) cadastral map change

Mapping method using digital cadastral map of the change, the digital cadastral map should be changed at any time with the case to change, but to preserve the historical figures for the period of every cadastral map the status quo.

Using simulation mapping cadastral map changes, cadastral Original pencil as a permanent preservation of information, is not altered; cadastral base map should be with the two cases to change at any time to change changed when the base map in the two copies (blue blueprint or photocopying chart) marked with a red pen to change the situation for your records. Can also be changed within a certain period of time the content of labeling in the same copy of a two base maps, the one to change the whole plan changes two or more than 1 / 3, should be re-drawn two base maps. According to the results or changes in case of change Kanzhang to the draft plan to amend the base map of the relevant contents of the point and get rid of waste, lines and annotation, the painting changed cadastral elements. To ensure the cadastral map of the current potential, when a map or in a neighborhood were to change an area of more than 1 / 2, should the map sheet or the neighborhood for basic measurement of the cadastral map updating, re-mapping cadastral Original pencil.

(B) cases map to change

Maps of land certificates were drawings, change cadastral survey, regardless of whether the boundary change were to change, after the change should be based on the cadastral map, or were to draft, according to "Cadastral Survey Instructions" the relevant provisions were re-drawn maps. The original maps were not planning to change, should be stamped with "change" the word seal to save.

3, other information changes

(A) Boundary point coordinates Volume Change

Boundary point coordinates on the list has been abandoned boundary point coordinates and the boundary dots red strokes off, in the appropriate location stamped "change" the word seal; analytical method used to re-measurement of boundary points, the original boundary point coordinates with the red strokes off, and in its top of the annotation of new measured data; the newly added boundary point coordinates and the boundary dots added to the list of coordinates; when the boundary point coordinates changes in larger volumes, should be re-establishment of community location point coordinates volumes.

(B) the area of summary tables and tables to change

In a street as a unit of the cases in an area of summary tables, crossed a change in the number of cases of land area, and stamped with "change" word stamp, the new increase in cases of land area is added to the list.

According to local conditions, depending on a certain period of time, based on the streets after the change, "were in an area of summary tables," change the area of urban land classification tables.

(C) were to change the adjacent

Were due to changes in the elements of land cadastral changes are brought to adjacent cadastral elements were to change, and the adjacent land were in need of change accordingly. If you were to change only give rise to changes in the adjacent number to four, while the adjacent land to other cadastral elements were unchanged, and the adjacent land were four conditions can temporarily make changes.